OpenVZ Forum


Home » Mailing lists » Devel » [patch 00/12] net namespace : L3 namespace - introduction
Re: [patch 00/12] net namespace : L3 namespace - introduction [message #17293 is a reply to message #17279] Sat, 20 January 2007 04:48 Go to previous messageGo to previous message
Herbert Poetzl is currently offline  Herbert Poetzl
Messages: 239
Registered: February 2006
Senior Member
On Fri, Jan 19, 2007 at 04:47:14PM +0100, dlezcano@fr.ibm.com wrote:
> This patchset provide a network isolation similar at what
> Linux-Vserver provides. It is based on the L2 namespaces and relies on
> the mechanisms provided by the namespace. This L3 namespaces does not
> aim to bring full virtualization for the network, it provides an IP
> isolation which can be reused for Linux-Vserver, jailed application or
> application containers.
> 
> A L3 namespace are always L2 s' childs and they can not create more
> network namespaces, furthermore, they lose their NET_ADMIN
> capability. They share their parent's network ressources. From the
> parent namespace, IP addresses are created and assigned to the
> different L3 childs. From this point, L3 namespaces can use their
> assigned IP address and all computed broadcast addresses.
  ~~~~~~~~~~~~~~~~~~~

okay, I conclude that this only handles a single address
for now. what are your plans to handle entire sets?

TIA,
Herbert

> Because the L3 namespace relies on the L2 virtualization mechanisms,
> it is possible to have several L3 namespaces listening on
> INADDR_ANY:port without conflict, that's allow to run several server
> without modifying the network configuration.
> 
> The loopback is a shared device between all L3 namespaces. To ensure
> the 127.0.0.1 address isolation, the sender store its namespace into
> the packet, so when the packet arrives, the destination namespace is
> already set, because "source" == "destination". By this way, it is
> easy to disable the loopback isolation and let the application to talk
> with application outside of the namespace via the 127.0.0.1 because we
> consider them trusted (like portmap).
> 
> The ifconfig / ip commands will only show IP addresses assigned to the
> L3 namespace. When a L3 namespace dies, the assigned IP address is
> released to its parent.
> 
> At the IP level, when a packet arrives, the L3 network namespace
> destination is retrieved from the destination address.
> 
> At the bind time, the address is checked against the assigned IP
> address.
> 
> -- 
> _______________________________________________
> Containers mailing list
> Containers@lists.osdl.org
> https://lists.osdl.org/mailman/listinfo/containers
_______________________________________________
Containers mailing list
Containers@lists.osdl.org
https://lists.osdl.org/mailman/listinfo/containers
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [PATCH] Statically initialize struct pid for swapper
Next Topic: [PATCH 0/6] containers: Generic Process Containers (V6)
Goto Forum:
  


Current Time: Fri Nov 01 09:30:11 GMT 2024

Total time taken to generate the page: 0.03388 seconds