OpenVZ Forum: Support » support for 3Ware \ 2 channel SATA RAID controller?

Home » General » Support » support for 3Ware \ 2 channel SATA RAID controller?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: support for 3Ware \ 2 channel SATA RAID controller? [message #1546 is a reply to message #1532]

Sun, 12 February 2006 18:46

snowdeal
Messages: 22
Registered: February 2006

Junior Member

kir wrote on Sat, 11 February 2006 18:48

Can you post the actual error message from rpm?

I'm not sure but I think that this driver is just compiled into the kernel, so it's not available (and not needed) as a module.

is there a relatively painless workaround for this? although i've done it before my kernel upgrading skills are a little rusty and i'm confused about why mkinitrd is failing if the driver is compiled into the kernel.

Report message to a moderator

[Message index]

		support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Sat, 11 February 2006 23:28
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: kir on Sat, 11 February 2006 23:48
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Sat, 11 February 2006 23:52
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Sun, 12 February 2006 18:46
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: vaverin on Mon, 13 February 2006 13:45
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Mon, 13 February 2006 19:08

Previous Topic:	Only one VPS - sane resource policies?
Next Topic:	assign public ( or private ) ip to new vps?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jul 08 06:44:25 GMT 2026

Total time taken to generate the page: 0.37956 seconds