OpenVZ Forum: Support » support for 3Ware \ 2 channel SATA RAID controller?

Home » General » Support » support for 3Ware \ 2 channel SATA RAID controller?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

support for 3Ware \ 2 channel SATA RAID controller? [message #1524]

Sat, 11 February 2006 23:28

snowdeal
Messages: 22
Registered: February 2006

Junior Member

hi,

i'm trying to install openvz on a 2.4ghz dual xeon box running red hat EL 3 with a 3Ware Escalade 8006 raid controller. after upgrading modutils [1], the rpm install fails with "No module 3w-xxxx found for kernel 2.6.8-022stab064.1-smp".

it looks like there is support for the card with virtuozzo [2]. is the controller not supported by default with openvz?

apologies in advance if this is a silly question - i never underestimate my ability to miss the obvious.

thanks,

eric

[1] http://forum.openvz.org/index.php?t=msg&goto=983&
[2] http://www.virtuozzo.com/en/products/virtuozzo/hcl/other/

[Updated on: Sat, 11 February 2006 23:49]

Report message to a moderator

[Message index]

		support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Sat, 11 February 2006 23:28
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: kir on Sat, 11 February 2006 23:48
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Sat, 11 February 2006 23:52
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Sun, 12 February 2006 18:46
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: vaverin on Mon, 13 February 2006 13:45
		Re: support for 3Ware \ 2 channel SATA RAID controller? By: snowdeal on Mon, 13 February 2006 19:08

Previous Topic:	Only one VPS - sane resource policies?
Next Topic:	assign public ( or private ) ip to new vps?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 27 13:39:03 GMT 2025

Total time taken to generate the page: 0.42438 seconds