OpenVZ Forum: Support » Asterisk G.729 codec...

Home » General » Support » Asterisk G.729 codec...

Tue, 12 June 2007 15:49

curx
Messages: 739
Registered: February 2006
Location: Nürnberg, Germany

Senior Member

Hi,

you can use a veth(ernet) device in your *-VE.

A veth(ernet) devices has a MAC address.

Add a veth(ernet) to VE:

# vzctl set <VEID> --netif_add eth0[,<mac>,<host_ifname>,<host_mac] [--save]

See more at:
http://wiki.openvz.org/Differences_between_venet_and_veth
http://wiki.openvz.org/Virtual_Ethernet_device
man-pages of vzctl

[Updated on: Tue, 12 June 2007 15:50]

		Asterisk G.729 codec... By: ugob on Tue, 12 June 2007 13:27
		Re: Asterisk G.729 codec... By: curx on Tue, 12 June 2007 15:49
		Re: Asterisk G.729 codec... By: ugob on Tue, 12 June 2007 16:35
		Re: Asterisk G.729 codec... By: curx on Wed, 13 June 2007 09:33
		Re: Asterisk G.729 codec... By: ugob on Wed, 13 June 2007 11:21
		Re: Asterisk G.729 codec... By: Vasily Tarasov on Thu, 14 June 2007 10:04
		Re: Asterisk G.729 codec... By: ugob on Thu, 14 June 2007 19:51
		Re: Asterisk G.729 codec... By: Vasily Tarasov on Fri, 15 June 2007 06:21
		Re: Asterisk G.729 codec... By: ugob on Wed, 12 September 2007 12:09
		Re: Asterisk G.729 codec... By: ugob on Fri, 05 October 2007 16:39
		Re: Asterisk G.729 codec... By: ugob on Tue, 16 October 2007 12:59
		Re: Asterisk G.729 codec... By: ugob on Tue, 16 October 2007 13:08
		Re: Asterisk G.729 codec... By: bobot23 on Tue, 23 October 2012 23:30
		Re: Asterisk G.729 codec... By: ugob on Wed, 24 October 2012 17:40

Previous Topic:	vzctl exec command
Next Topic:	100% CPU usage

Goto Forum:

] [

]

Current Time: Wed Feb 18 16:25:12 GMT 2026

Total time taken to generate the page: 0.17458 seconds