OpenVZ Forum: Support » *SOLVED* Set available memory

Home » General » Support » *SOLVED* Set available memory

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Set available memory [message #13950 is a reply to message #13947]

Fri, 08 June 2007 11:29

rickb
Messages: 368
Registered: October 2006

Senior Member

Hi. I would set your privvmpages to 4GB, oomguarpags to 1.5GB, vmguarpags to 1.5GB, numproc to 5000. Add at least 2GB swap on your node just for safety.

remember the UBCs are in pages. 1 page = 4096 byte on 32bit.

This will give your VE the memory capabilities you are looking for.

-------------
Common Terms I post with: http://wiki.openvz.org/Category:Definitions

UBC. Learn it, love it, live it: http://wiki.openvz.org/Proc/user_beancounters

[Updated on: Fri, 08 June 2007 12:37]

Report message to a moderator

[Message index]

		SOLVED Set available memory By: mdekkers on Wed, 06 June 2007 15:44
		Re: Set available memory By: rickb on Wed, 06 June 2007 15:49
		Re: Set available memory By: mdekkers on Wed, 06 June 2007 15:58
		Re: Set available memory By: mdekkers on Fri, 08 June 2007 11:20
		Re: Set available memory By: rickb on Fri, 08 June 2007 11:29
		Re: Set available memory By: mdekkers on Fri, 08 June 2007 11:53
		Re: Set available memory By: rickb on Fri, 08 June 2007 12:39

Previous Topic:	KNOWN ISSUE VZquota and Shared VEs with NFS
Next Topic:	SOLVED Searching for OpenVZ kernel 2.6.9-42

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Feb 05 15:52:45 GMT 2026

Total time taken to generate the page: 0.28100 seconds