OpenVZ Forum: Support » *SOLVED* Can't access

Home » General » Support » *SOLVED* Can't access

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

*SOLVED* Can't access [message #13198]

Wed, 23 May 2007 11:51

padde77
Messages: 2
Registered: May 2007

Junior Member

Hi,

I´ve set up an VE, and when I start it, no errors occurs.
I've given an IP from my eth0:1 to the VE, it starts with it without any problems.
But if I want to access the IP (VE), I come out to my original server root. No VE is accessiable from outer network.

What can I do?

Sorry for my bad english.

Patrick

[Updated on: Thu, 24 May 2007 15:32] by Moderator

Report message to a moderator

Re: Can't access [message #13199 is a reply to message #13198]

Wed, 23 May 2007 11:55

kir
Messages: 1645
Registered: August 2005
Location: Moscow, Russia

Senior Member

First, you should enable port forwarding as per http://wiki.openvz.org/Quick_installation#sysctl (i.e. modify /etc/sysctl.conf and then run sysctl -p)

Next, you do not want that IP address to present on your eth interface -- remove it from there.

Kir Kolyshkin