OpenVZ Forum


Home » Mailing lists » Users » Would a hardware change break LAN configuration?
Re: Would a hardware change break LAN configuration? [message #11854 is a reply to message #11851] Tue, 10 April 2007 06:41 Go to previous messageGo to previous message
dev is currently offline  dev
Messages: 1693
Registered: September 2005
Location: Moscow
Senior Member
Jim,

No OpenVZ doesn't affect networking directly
Most likely you have misconfigured something.
it can be different situations:
- e.g. devices were renamed after the addition. i.e. eth0 become eth2 etc.
and settings are applied to wrong devices.
- VPSs can stop talking to LAN if default routing is via these unworking devices.
- etc. etc. etc.
to be able to resolve it we need dmesg from both boots (with and w/o PCI-X),
and 2 outputs of:
# ip a l
# ip r l
# iptables -L
# iptables -L -t mangle

Thanks,
Kirill

Jim Archer wrote:
> Hi All…
>
> I have a SuperMicro system running OpenVZ on Debian Etch AMD64. It has 2
> ethernet ports on the system board. Recently, I added a PCI-X dual port
> Ethernet card. I was unable to make these two ports talk to the network
> and also, this addition caused the VPSes to be unable to talk to the LAN.
> I deconfigured the new ports in /etc/network/interfaces and fixed it after
> a reboot.
>
> Is there any reason OpenVZ would have caused this? I can’t seem to find
> an alternative cause but I can’t see why OpenVZ would do it either.
>
> Thanks…
>
>

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Previous Topic: Wrong links for downloads
Next Topic: Need help understanding kernel version numbers
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Feb 18 19:53:02 GMT 2026

Total time taken to generate the page: 0.17360 seconds
Powered by FUDforum Powered by Virtuozzo Containers