| *SOLVED* [NOAPIC] OVZ Kernels and e1000 nic [message #11415] |
Thu, 22 March 2007 22:42  |
devonblzx
Messages: 127
Registered: December 2006
|
Senior Member |
|
|
I don't know if anyone else has run into problems but I cannot seem to get any OpenVZ kernels working with my network interface. I am using built in Intel Gigabit NICs using the e1000 module.
I have tried the following kernels with the following errors:
2.6.18-023 (brand new kernel) - when booting eth0 in the initscript it gives me an error that it is trying to ping 192.168.1.1 and it times out with a [failed].
2.6.18-023 custom build - told me that it could not find raid5 module or ahci module and gave me a sync error when trying to load either my hard drives or my RAID. (I am using a Software RAID and I had CONFIG_MD_RAID456=m and CONFIG_SCSI_SATA_AHCI=m)
2.6.16 - when booting the nic in initscripts it gave me an error about having the wrong MAC address and returned [failed].
2.6.9 custom build - gave me the same error as 2.6.18-023 default (1st above).
2.6.9 - hung on bootup, did not go far...
As you can see I have had a lot of issues with this system and trying to get OpenVZ to work. I have tried much but nothing seems to be fixing it.
The specs of my system are below:
Tyan S5372
Dual Intel GIG NIC (e1000)
Software RAID5 (5x250GB WD RE SATAII)
Dual Intel E5310 (8x1.6ghz)
CentOS 4.4 (x86_64)
Thanks in advance
ByteOnSite President
[Updated on: Tue, 27 March 2007 08:06] by Moderator Report message to a moderator |
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
