Re: Create FC6 Template [message #11153 is a reply to message #11062] |
Wed, 14 March 2007 12:40 |
Alexandr Andreev
Messages: 35 Registered: October 2006
|
Member |
|
|
You can also read http://wiki.openvz.org/Debian_template_creation
and http://wiki.openvz.org/Slackware_template_creation to understand how to create a template from __any__ Linux distributive.
The main problem is to create FC6 rootfs image. If you have a rootfs image, you have everything to make your own template.
To create any rootfs you can:
1. Install vmware (or get a real host/new HW disc);
2. Install any linux distributive on it. Use minimal installation!
3. Make tgz image of root filesystem on your target PC (vmware) (tar czf /rootfs.tgz --exclude /rootfs.tgz /)
4. Copy this image to a host, where openvz is installed. (You can copy it by network or flash and so on...)
5. Choose some VEID, to use (assume 777)
6. Untar your rootfs image on a host with OpenVZ:
# cd /vz/private/777
# gunzip -dc rootfs.tgz |tar -xvf -
# rm /vz/private/777/rootfs.tgz
7. Make config for this VE
# vzctl set 777 --applyconfig vps.basic --save
8. ...
Read wiki pages above to see all next steps required
[Updated on: Wed, 14 March 2007 12:41] Report message to a moderator
|
|
|