OpenVZ Forum


Home » General » Support » Open a range of port in the container (Firewall scrip)
Open a range of port in the container [message #46741] Thu, 07 June 2012 16:16
aberrio is currently offline  aberrio
Messages: 1
Registered: June 2012
Location: Tulsa
Junior Member
Hi,

I set up my firewall following this HOWTO http: //wiki.openvz.org/Setting_up_an_iptables_firewall I need to open a range of port in the container how do I t do that in the script.

With iptable you do this 10000:20000 but I do not know if this work in the script too!.

Please advise.


Regards,

Al

Report message to a moderator

Previous Topic: Best Linux Distro to use with OpenVZ?
Next Topic: Multiple Container IPs on Separate Networks and Network Access
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Feb 20 21:47:50 GMT 2026

Total time taken to generate the page: 0.24799 seconds
Powered by FUDforum Powered by Virtuozzo Containers